Mazda CX-5 Forums

Technical Section => Troubleshooting => Topic started by: Harllequin on August 20, 2020, 05:20:12 pm

Title: SCBS inspection required after ABS sensor replacement.
Post by: Harllequin on August 20, 2020, 05:20:12 pm

Hi there folks.

I've replaces the wheel bearing on the drivers side and damaged the ABS sensor in the process.
I've replaced the sensor with a new one but now I have the following warning light.

SCBS inspection required.

I've asked the local mazda garage about resetting it but they want to charge a minimum of £80
I've tried my OBD2 reader but it just comes back with reset failed.

Is there another way to reset it can anyone enlighten me lease.

Thank you very much in advance

Title: Re: SCBS inspection required after ABS sensor replacement.
Post by: Gel on August 21, 2020, 11:20:41 am

An independent with good OBD Analyser would do it much cheaper I reckon.

Title: Re: SCBS inspection required after ABS sensor replacement.
Post by: George IV on August 29, 2020, 04:59:33 pm

Dont know if this helps  I had a similar problem recently  Coming home after a major service I got message  SCBS Forward Fault  contacted Mazda who like you wanted £90 to check it out.  Following day after starting engine for third time the warning went off and when i checked with OBD2 reader there were no codes logged   It may reset itself or as previously mentioned  get local garage with a snap on or similar reader to reset it